Sanyo PJ-Net Organizer Plus POA-LN02 - Manual (Page 22)

Chapter 2 Installation
Configure the network with the computer
This example explains how to set the following configuration.
IP Address : 192.168.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
DNS : 0.0.0.0
The default network configuration is set as follows.
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
Make sure that the monitor is connected to the network and then connect the AC cord to
the outlet.
1
Temporarily* 1 set up your computer network configuration to the same IP network number
as the LD-Net Organizer. For example, change your computer network configuration
as follows and restart the computer.
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default Gateway : (blank)
DNS : (blank)
The network configuration of computer differs depending on each network environment
or your computer. For further information, please see the chapter “Configure the network
of computer” on page 24.
*1 Change your computer's network configuration temporarily. After completing the set up for the
monitor, you must set up again to the original network configuration for your computer. It is rec-
ommended to make a note of those network settings.