Sanyo PJ-Net Organizer Plus POA-LN02 - Manual (Page 107)

107
LD-NET ORGANIZER
OWNER'S MANUAL
Q&a
installation/access
Q
Why doesn’t the setting page appear in my web browser?
A
Following causes are possible. Please check them.
1. The monitor does not connect to the network.
Check LED indicators status ( p.17).
- Check the connection of LAN cable if the LINK indicator does not illuminate
red.
- Check the network configuration of the monitor if ACT indicator does not
illuminate green.
2. Wrong network configuration of the monitor
Check the network configuration of the monitor ( p.37).
3. Wrong network configuration of the computer.
Check the network configuration of the computer.
4. The network unit is used with the default setting ( p.21).
5. The proxy setting of the web browser is not set correctly ( p.100).
6. The computer does not provide TCP/IP protocol.
Q
No setting page in my web browser? Is the problem in the network or in
the monitor? I would like to find out the problem whether it is in the net-
work or in the monitor
A
Check it by the following steps
1. Disconnect the monitor from the network and connect the monitor and com-
puter with the UTP cross cable directly.
2. Change network configuration of the computer and monitor as shown in the
example below.
(Monitor setting)
IP Address
: 192.168.0.2
Subnet Mask : 255.255.255.0
Default gateway : 0.0.0.0
DNS : 0.0.0.0
(Computer setting)
IP Address
: 192.168.0.5
Subnet Mask : 255.255.255.0
Default gateway : (blank)
DNS : (blank)
Q&A