John Deere 5310 S - Manual (Page 83)

Wheels, Tyres and Treads
PY80265,05I0183 –19–12SEP05–1/2
Tread Settings—Multi-Position Rear Wheels
Wheel tread on rear axle with multi-position wheels
can be adjusted by repositioning or exchanging the
rims or by reversing the wheel disks.
Wheel tread can also be adjusted by exchanging the
complete wheel to the opposite side of the tractor (This
maneuver permits the change from disk-dished-in to
disk-dished-out operations without disassembling the
wheel). When changing rear wheels from one side to
the other, the arrow on side wall of tyre points in the
direction of forward rotation.
The relationship of the wheel disk and rim in obtaining
the different tread settings is shown in the diagrams on
the facing page.
A study of these diagrams, before attempting to
change tread settings, will save unnecessary labor.
IMPORTANT: After setting wheel spacing, tighten
rim-to-disk and disk-to-flange bolts.
Drive tractor 100 m (109 yd) and
tighten again.
Specification
Multi-Position Rear Wheels
Rim-to-Disk—Torque
245 N•m (180 lb-ft) ............................................
Multi-Position Rear Wheels
Disk-to-Flange—Torque
550 N•m (406 lb-ft) ........................................
NOTE: Tread settings are measured at bottom of
centerline.
STEEL DISKS
REAR TREAD WIDTH
Centerline-to-Centerline
Diagram Tyre Sizes
18.4-30
A 1379 mm (54.3 in.)
B 1475 mm (58.1 in.)
C 1579 mm (62.2 in.)
D 1678 mm (66.1 in.)
E 1782 mm (70.2 in.)
PY80265,05I0183 –19–12SEP05–2/2
IN227
–UN–24MAY00
75-6
082206
PN=81