John Deere 5310 S - Manual (Page 114)

Service—Every 1250 Hours
PY80265,05I0232 –19–12SEP05–1/1
Change Transmission-Hydraulic Oil and
Filter
PY4039
–UN–17JUL04
PY4019
–UN–15JUL04
A—Transmission Case
B—Drain Plug
C—Filter
D—Dipstick
1. Lower rockshaft to remove trapped oil.
2. Remove drain plug (B) from transmission case (A) and
drain oil. Dispose of waste oil properly.
3. Replace filter (C) while changing oil. Apply a film of oil
to new filter gasket and install new filter. Hand tighten
only.
4. Fill system with transmission-hydraulic oil. (See Fuels,
Lubricants and Coolant section.)
Specification
Transmission Oil—Capacity 38 L ...............................................................
5. Check oil level by means of dipstick. Make sure oil
level is to full level mark. Check again after operating
for five minutes. Add oil if necessary.
120-1
082206
PN=112