John Deere 5310 S - Manual (Page 67)

Drawbar and PTO
PY80265,05I0159 –19–12SEP05–1/1
Attaching PTO-Driven Implement
PY1094
–UN–10APR05
CAUTION: Stop engine before attaching
implement or working in area of implement
hitch.
1. Attach implement to tractor before connecting PTO
drive line. Raise hitch to upward position if it is not to
be used.
2. Range shift lever in neutral (N), turn key to OFF
position, pull fuel shut-off knob to stop engine and set
brakes.
3. Attach implement to 3-Point Hitch, be sure drawbar will
not interfere. Remove it if necessary.
4. Rotate PTO shield upward for clearance. With engine
off, turn shaft slightly by hand if necessary to line up
splines. Connect drive line to PTO shaft. Pull out on
shaft to be sure drive line is locked to PTO shaft. Place
PTO shield in downward position.
5. Be sure all shields are in place and in good condition.
Never operate PTO unless master shield is properly
installed. WITH ENGINE STOPPED, check integral
shields on drive line by making sure they rotate freely
on shaft. Lubricate or repair as necessary.
6. Check carefully for any interference, make sure hitch is
raised to the upper position if it is not used.
65-2
082206
PN=65