John Deere 5310 S - Manual (Page 43)

Operating the Engine
PY80265,05I0133 –19–12SEP05–1/1
Stopping the Engine
PY4501
–UN–13JAN05
A—Hand Throttle
B—Key Switch OFF
1. Pull hand throttle (A) down to slow idle position. Allow
engine to idle for one to two minutes.
2. Put gear shift lever in Park position (B).
IMPORTANT: Cooling of certain engine parts is
provided by engine oil. Stopping a hot
engine suddenly could cause damage
to these parts by overheating or lack of
lubrication.
3. Turn key switch to the OFF position.
CAUTION: Engine should not be shut off at high
RPM, deacceleration should be done slowly &
engine should be kept at idling for 15-30 sec
when the engine is stopped for a gap of 1 hr.
Remove key from key switch to prevent
operation by untrained personnel.
PY80265,05I0134 –19–12JUL06–1/1
Using Booster Battery
PY5821
–UN–12JUL06
A—Tractor Battery Positive (+) Post
B—Engine Ground
C—Booster Battery Negative (—) Post
D—Booster Battery Positive (+) Post
Battery gas is explosive:
•
DO NOT smoke while charging battery.
•
Keep all flames and sparks away.
•
DO NOT charge frozen battery.
•
DO NOT connect booster battery negative (—) cable to
starting vehicle negative (—) terminal.
1. Access battery. (See procedure in Service section.)
2. Connect positive (+) booster cable to booster battery
positive (+) post (D).
3. Connect the other end of positive (+) booster cable to
tractor battery positive (+) post (A).
4. Connect negative (—) booster cable to booster battery
negative (—) post (C).
5. Connect the other end of negative (—) booster cable to
engine ground (B), away from battery and starter.
45-8
082206
PN=41