Fig. 01.7 – Jaguar S-TYPE 2004 User Manual
Page 44
The following abbreviations are used to represent values for Control Module Pin-Out data
I
Input
PG
Power Ground
C
CAN Network
D
Serial and Encoded Data
O
Output
SS
Sensor / Signal Supply V
S
SCP Network
V
Voltage (DC)
B+
Battery Voltage
SG
Sensor / Signal Ground
D2
D2B Network
PWM Pulse Width Modulated
CAUTION: The information on this data page is furnished to aid the user in understanding circuit oper ation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, fuses, grounds, control
modules and control module pins.
DATE OF ISSUE: June 2002
Fig. 01.7
COMPONENTS
Component
Connector(s)
Connector Description
Location
EMS CONTROL RELAY
—
—
FRONT POWER DISTRIBUTION FUSE BOX – R5
ENGINE CONTROL MODULE
PI1
134-WAY / BLACK
FRONT BULKHEAD, PASSENGER SIDE
FRONT POWER DISTRIBUTION FUSE BOX
—
—
ENGINE COMPARTMENT, RH SIDE
HO2S RELAY
—
—
FRONT POWER DISTRIBUTION FUSE BOX – R2
IGNITION COIL RELAY
—
—
FRONT POWER DISTRIBUTION FUSE BOX – R3
HARNESS IN-LINE CONNECTORS
Connector
Connector Description / Location
Location
CP1
10-WAY / BLACK / INTERCOOLER PUMP LINK LEAD
ENGINE COMPARTMENT, RH FRONT, ADJACENT TO RADIATOR
FH1
20-WAY / BLACK / CABIN HARNESS TO FRONT HARNESS
RH ‘A’ POST, LOWER
IL10
12-WAY / BLACK / ENGINE HARNESS TO FUEL INJECTOR LINK
REAR OF ENGINE
IS5
6-WAY / BLACK / ENGINE HARNESS TO FUEL INJECTOR LINK
ENGINE, LH REAR
IS6
6-WAY / BLACK / ENGINE HARNESS TO FUEL INJECTOR LINK
ENGINE, RH REAR
PI41
42-WAY / BLACK / ENGINE HARNESS TO VEHICLE HARNESSES
ENGINE COMPARTMENT, BULKHEAD, PASSENGER SIDE
GROUNDS
Ground
Location
FH42
ENGINE COMPARTMENT, BEHIND RH HEADLAMP
FOR CONTROL MODULE PIN-OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN-OUT INFORMATION
Engine Control Module
Pin
Description and Characteristic
O
PI1-40
EMS CONTROL RELAY DRIVE: TO ACTIVATE, ECM SWITCHES CIRCUIT TO GROUND