JVC GR-DVX70 - Manual (Page 79)

EN
79
7
POSITION CAMCORDERS
[For both receiving and transmitting camcorders]
Position the transmitting and receiving camcorders so
that their infrared transmitter and receiver face each
other.
•The distance between them should be less than
50 cm and the transmitter and receiver should be
angled no more than 15˚ to each other.
8
TRANSMIT IMAGE
[For transmitting camcorder]
Press START/STOP/TRANS. Image transmission starts
and the message “IN PROGRESS” is displayed.
9
RECEIVE IMAGE
[For receiving camcorder]
Rotate MENU/SET until “RECEIVE” appears and press
it. Image reception starts and the message “IN
PROGRESS” is displayed. Reception is complete
when the message disappears.
NOTES:
● Be sure to supply power from the AC Power Adapter/
Charger instead of the battery pack.
● [For transmitting camcorder]
• Be sure to set “IrTran-P” back to “OFF” when the
transmission is finished.
• An image with a title/frame can also be transmitted.
• If the message “COMMUNICATION FAILED” is
displayed within approx. 60 seconds after START/
STOP/TRANS is pressed, check the equipment
orientation, power supplies, etc. and retry the
transmission.
• To abort transmission in the middle, press START/
STOP/TRANS. The message “COMMUNICATION
FAILED” is displayed.
● [For receiving camcorder]
• If the message “COMMUNICATION FAILED” is
displayed, check the equipment orientation, power
supply, etc. and retry the transmission.
• “IrTran-P” automatically returns to “OFF” when the
reception is complete or it fails.
A M
MENU/SET Dial
START/STOP/
TRANS Button