JVC GR-DVX70 - Manual (Page 42)

42
EN
,,,,
,,,,
,,,,
,,,,
,,,
,,,,
,,,,
,,,,
,,,,
,,,
,,,,
,,,,
,,,,
,,,,
,,,
PICTURE WIPE OR DISSOLVE SELECTION
(
, , , , , and
)
Combine the Picture Wipe and Dissolve functions for a
professional transition effect. There are 6 Picture Wipe
effects and 1 Dissolve effect. The Picture Wipe or Dissolve
works when recording is started.
Before the following steps, perform steps 1 through 4 on
pg. 41.
5
STORE SCENE IN MEMORY
Engage the Record-Standby mode.
If you select Picture Wipe/Dissolve during
recording . . .
.... press START/STOP when one scene is finished.
The point at which the scene ended is stored in
memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
.... press START/STOP to start recording and press it
again when one scene is finished. The point at
which the scene ended is stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode after performing a Picture Wipe/
Dissolve . . .
.... the point at which the scene ended is already
stored in memory.
6 START RECORDING
If you start recording a new scene within 5 minutes of
the end of the previous recording (without having
turned the camcorder’s power off), the previous scene
wipes out, revealing the new scene.
NOTES:
● You can extend the length of a Fade or Wipe by pressing
and holding START/STOP .
● If the power is turned off after a scene is finished
recording, the stored point is erased.
This disables the Picture Wipe/Dissolve combination.
When this happens, the Picture Wipe/Dissolve indicator
blinks. Try recording again, but do not turn the power off
when you are finished. Please be advised that power
also shuts off automatically if 5 minutes elapse in the
Record-Standby mode.
● The sound at the end of the last recorded scene is not
stored.
Previous scene end
START/STOP Button
Within 5 minutes . . .
Wipe-in
[Ex.: WIPE – SCROLL]
RECORDING Advanced Features For Video And D.S.C. (cont.)