JVC RX-D412BUJ - Manual (Page 30)

4
Press MEMORY again while the selected
preset number is flashing on the display.
5
Repeat steps 1 to 4 until you store all the
desired channels.
To erase a stored preset channel
Storing a new channel on a used preset number erases the
previously stored one.
7 To tune in a preset channel
From the remote control:
1
Press XM.
The last received channel is tuned in.
2
Press the numeric buttons (0 – 9,
h10) to
select a preset channel number.
• For preset number 5, press 5.
• For preset number 10, press
h10, 1, then 0.
• For preset number 25, press h10, 2, then 5.
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2 again.
1
Turn SOURCE SELECTOR to select “XM.”
The last received channel is tuned in.
2 Press TUNER PRESET.
“P” flashes on the display, and MULTI JOG now works for
selecting preset channels.
3
Turn MULTI JOG to select a preset
number.
• To increase the preset numbers, turn MULTI JOG
clockwise.
• To decrease the preset numbers, turn MULTI JOG
counterclockwise.
Changing the channel information
While listening to the XM Satellite Radio, the currently
selected channel information appears on the display.
You can change the type of channel information.
From the remote control ONLY:
Press DISPLAY.
Each time you press the button, the channel information
changes as follows:
CHAN (channel name)* = NAME (artist name/feature) =
TITLE (song/program title) = CAT (category name) = (Back
to the beginning)
* CHAN (channel name) is the initial setting.
EX.: When the category name is selected:
NOTES
• If you turn off the power or select another source, the display is
changed back to the initial setting.
• When you tune in to another channel, the channel name appears
on the display and then the channel information you have selected
appears.
• When all the text information cannot be shown on the display at a
time, the text scrolls.
• Some characters cannot be displayed correctly.
After 1 second
7 Messages on the display
When problems occur, a message appears on the display. In this case, refer to the following solution.
Message Possible cause Solution
NO SIGNAL Signals are too weak. Move the XM Passport Home Dock antenna
near a south-facing window or where
“Channel 1” can be heard clearly.
CHECK ANTENNA The XM Passport Home Dock antenna is
not connected properly. Check the connection (see page 7).
LOADING This receiver is loading the channel
information and audio data. It takes a few minutes to complete. Wait until
loading is finished.
OFF AIR Selected channel is not currently
broadcasting any signal. Select another channel.
UPDATING The latest encryption code is being
updated. Wait until updating is finished.
• Channel number and “-----”
• Preset number, channel
number, and “-----”
No text information for the selected
channel is available.
—
• Channel number and “CH---”
• Preset number and “--- Selected channel does not exist or is not
subscribed yet.
—
28
24-28_Radio.indd 28 24-28_Radio.indd 28 06.6.27 2:41:41 PM 06.6.27 2:41:41 PM