JVC RX-D412BUJ - Manual (Page 27)

3
Press the numeric buttons (0 – 9,
h10)
to select a channel number while the
channel number position is flashing.
• For channel number 5, press 5.
• For channel number 10, press
h10, 1, then 0.
• For channel number 25, press h10, 2, then 5.
4
Press MEMORY again while the selected
channel number is flashing on the
display.
The selected channel number stops flashing.
The channel number is assigned to the station.
5
Repeat steps 1 to 4 until you store all the
stations you want.
To erase a stored preset station:
Storing a new station on a used channel number erases the
previously stored one.
7 To tune in a preset station
From the remote control:
1 Press FM/AM to select the band.
The last received station of the selected band is tuned in
and the numeric buttons now work for selecting preset
channels.
• Each time you press FM/AM, the band alternate between
“FM” and “AM.”
2 Press the numeric buttons (0 – 9, h10) to
select a preset channel number.
• For channel number 5, press 5.
• For channel number 10, press
h10, 1, then 0.
• For channel number 25, press h10, 2, then 5.
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2 again.
1
Turn SOURCE SELECTOR to select “FM” or
“AM.”
The last received station of the selected band is tuned in.
2
Press TUNER PRESET.
“P” appears on the display, and MULTI JOG now works for
selecting preset channels.
3
Turn MULTI JOG to select a preset
channel number.
• To increase the preset channel numbers, turn MULTI JOG
clockwise.
• To decrease the preset channel numbers, turn MULTI
JOG counterclockwise.
Selecting the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, you
can change the FM reception mode.
• You can store the FM reception mode for each preset station
(see page 24).
From the remote control ONLY:
While listening to an FM station, press FM
MODE.
• Each time you press the button, the FM reception mode
alternates between “AUTO MUTING” and “MONO.”
AUTO MUTING Normally select this.
When a program is broadcast in stereo, you
will hear stereo sound; when in monaural,
you will hear monaural sound. This mode is
also useful to suppress static noise between
stations. The AUTO MUTING indicator lights
up on the display.
MONO Select this to improve the reception (but
stereo effect will be lost).
In this mode, you will hear noise while
tuning in to the stations. The AUTO MUTING
indicator goes off from the display. (The
STEREO indicator also goes off.)
Initial setting: AUTO MUTING
2 1, 3
25
24-28_Radio.indd 25 24-28_Radio.indd 25 06.6.27 2:41:38 PM 06.6.27 2:41:38 PM