JVC RX-D412BUJ - Manual (Page 29)

7 To tune in to channels
From the remote control ONLY:
Channel Search
You can search and tune in to all channels.
1
Press XM to select “XM” as the source.
2
Press repeatedly or hold CHANNEL
+/– until the desired channel number
appears on the display.
• Pressing (or holding) CHANNEL + increases the channel
number.
• Pressing (or holding) CHANNEL – decreases the channel
number.
NOTE
While searching, the invalid and unsubscribed channels are skipped.
Category Search
You can select the channel category and tune in to only the
channels included in the selected category.
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2 again.
1
Press XM to select “XM” as the source.
2
Press CAT 9 or ( CAT.
The receiver enters the Category Search mode.
The category name of the currently selected channel
appears and “>” starts flashing on the display for about 15
seconds.
3
Press CAT 9 or ( CAT repeatedly to
display the desired category name on
the display while “>” is flashing.
4
Press repeatedly or hold CHANNEL
+/– until the desired channel is tuned in.
• Pressing (or holding) CHANNEL + increases the channel
number included in the selected category.
• Pressing (or holding) CHANNEL – decreases the channel
number included in the selected category.
NOTE
While searching, the invalid and unsubscribed channels are skipped.
Direct Channel Access
You can tune in to the desired channel directly by entering the
channel number.
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2 again.
1
Press XM to select “XM” as the source.
2 Press the DIRECT button.
The receiver enters the Direct Access mode and the
numeric buttons now work for entering channel numbers.
The channel number position starts flashing on the display
for about 5 seconds.
3
Press the numeric buttons (0 – 9,
h10) to
enter the desired channel number while
the channel number position is flashing.
• For channel number 005, press 5.
• For channel number 010, press
h10, 1, then 0.
• For channel number 025, press h10, 2, then 5.
• For channel number 115, press h10, h10, 1, 1, then 5.
Using preset tuning
Once a preset number is assigned to a channel, the channel
can be quickly tuned in by selecting the number. You can
preset up to 30 channels.
7 To store the preset channels
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
2 again.
From the remote control ONLY:
1
Tune in to the channel you want to
preset (see “To tune in to channels” on
the left column).
2
Press MEMORY.
The preset number position starts flashing on the display
for about 5 seconds.
3
Press the numeric buttons (0 – 9,
h10) to
select a preset number while the preset
number position is flashing.
• For preset number 5, press 5.
• For preset number 10, press
h10, 1, then 0.
• For preset number 25, press h10, 2, then 5.
Continued on the next page
Channel number Category name
27
24-28_Radio.indd 27 24-28_Radio.indd 27 06.6.27 2:41:40 PM 06.6.27 2:41:40 PM