JVC RX-D412BUJ - Manual (Page 10)

CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by
the speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
7 Connecting the speakers
Turn off all components before making connections.
To connect the center speaker and the front speakers
1
Cut, twist and remove the insulation at
the end of each speaker cord.
2
Turn the knob counterclockwise.
3
Insert the speaker cord.
• For each speaker, connect the (+) and (–) terminals on
the rear panel to the (+) and (–) terminals marked on the
speakers.
4
Turn the knob clockwise.
Connecting the speakers
Do not connect the AC power cord until all other connections have been made.
7 Speaker Layout Diagram
Right surround
back speaker (SBR)
Left surround back
speaker (SBL)*
Powered
subwoofer (SW)
Center speaker (C)
Right surround speaker (SR)
Left surround speaker (SL)
Right front
speaker (R)
Left front
speaker
(L)
To connect the surround speakers and the surround back
speakers
1
Cut, twist and remove the insulation at
the end of each speaker cord.
2
Open the terminal (1), then insert the
speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on
the rear panel to the (+) and (–) terminals marked on the
speakers.
3
Close the terminal.
* When using a single speaker for the surround back
speaker
You can enjoy the surround sound by one surround back
speaker. When using one surround back speaker,
– set “S BACK OUT” to “1SPK” (see page 31) and
– connect the surround back speaker to the left surround
back speaker terminal. (No sound comes from the
speaker if you connect it to the right surround back
speaker terminal.)
7 Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord with
RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or subwoofer, perform
Precise Surround Setup to adjust the speaker settings
automatically (see pages 16 to 19).
NOTE
You can place a subwoofer wherever you like since bass sound is non-
directional. Normally place it in front of you.
FL
SL
C FR
SW
SR
SBR SBL (SB*)
1 2 3
1 2 4 3
8
06-15_Connection.indd 8 06-15_Connection.indd 8 06.6.27 2:35:43 PM 06.6.27 2:35:43 PM