JVC TH-A75 - Manual (Page 71)

67
SOLUTION
Connect the cord correctly.
(See page 7.)
Select the correct input mode on
the TV.
Change the scanning mode to
“INTERLACE.” (See page 19.)
Use a playable disc. (See page 5.)
Replace the disc. (See page 5.)
Enter password to change the
Parental Lock level. (See page 58.)
Load the disc correctly. (See page
20.)
Replace the disc. (See page 5.)
Replace or clean the disc. (See
page 65.)
Connect the center unit and TV
directly.
Change the setting for
“PROGRESSIVE MODE.” (See page
53.)
Set the monitor type correctly. (See
page 53.)
Set the TV correctly.
Select the correct video output jack
type to watch the DVD playback.
(See page 25.)
Some DVDs are programmed to
always display no subtitle initially. If
this happens, press SUBTITLE on
the remote control after starting
play. (See page 37.)
Some DVDs are programmed to
always use the original language
initially. If this happens, press
AUDIO on the remote control after
starting play. (See page 37.)
Reconnect the antennas correctly
and securely.
Change the position and direction
of the AM loop antenna.
Try to change the Beat Cut mode.
(See page 23.)
Extend the FM antenna at the best
position.
Connect an external FM antenna
(see page 9), or contact your
dealer.
Select another station.
Check with your dealer to be sure
you have a correct antenna.
DVD Playback
POSSIBLE CAUSE
The video cord is not connected
correctly.
Incorrect TV input mode is selected.
The scanning mode is set to
“PROGRESSIVE” though the system is
connected to the TV which does not
support the progressive video input such
as a conventional TV.
The disc is not playable.
The disc Region Code numbers are
incompatible.
Playback is restricted by Parental Lock.
The disc is loaded with its label and data
sides inverted.
An unplayable disc is inserted.
The disc is scratched or dirty.
A VCR is connected between the center
unit and the TV.
“PROGRESSIVE MODE” may not be set
appropriately for the current disc.
“MONITOR TYPE” is not set correctly.
The TV is not set correctly.
The video output jack type to watch the
DVD playback is not set correctly.
Antennas are disconnected.
The AM loop antenna is too close to the
center unit.
Beat Cut mode is not set properly.
The supplied FM antenna is not properly
extended and positioned.
The received signal is too weak.
The station is too far away.
An incorrect antenna is used.
PROBLEM
No picture is displayed on the TV
screen.
No picture is displayed on the TV
screen, the picture is blurred, or the
picture is divided into two parts.
A disc cannot be played.
A disc cannot be played and “0:00” is
displayed on the display window.
Video and audio are distorted.
The picture does not fit the TV screen.
One touch DVD play does not work
though you have connected AV
COMPU LINK cord correctly.
No subtitle appears on the TV screen
though you have selected as your
initial subtitle language.
Audio language is different from the
one you have selected as your initial
audio language.
Hard to listen to broadcast because of
noise.
—For AM
—For FM
Continuous static during FM
broadcasts.
FM/AM
EN60-70.TH-A75[A]_f 02.10.11, 2:57 PM 67