JVC TH-A75 - Manual (Page 66)

62
By changing the remote control signals from preset ones to
the other manufacturers’, you can use the remote control
supplied for this system to operate other manufacturers’ TVs,
VCRs, CATV converters and DBS tuners.
• When operating other video equipment, aim the remote
control directly at the remote control sensor on each
equipment. Refer also to the instruction manuals supplied
with your equipment.
7 Operating TV
• You can operate a JVC TV without setting the remote
control signal setting.
* Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
1 Set the remote control mode selector to
“AUDIO/TV/VCR.”
2 Press and hold TV .
• Keep it pressed up to step 5.
3 Press TV CONTROL.
4 Press the number buttons (1-9, 0) to enter a
manufacturer’s code (2 digit).
See the list below to find the codes.
Ex: For a Sanyo TV, press 1, then 3.
For a Toshiba TV, press 0, then 8.
5 Release TV .
6 Try to operate your TV by pressing TV .
When your TV turns on or off, you have entered the
correct code.
If more than one code is listed for your brand of TV, try
each one until you enter the correct one.
After setting transmittable signals, you can use the
following buttons for the TV operations.
TV :Turns the TV on and off.
TV VOL +/– :Adjusts the volume.
TV/VIDEO :Selects the input mode (either TV or VIDEO).
After pressing TV CONTROL:
CHANNEL +/– :Changes the channels.
1-10, 0, +10 (100+) :Selects the channel.
TV RETURN :Alternates between the previously
selected channel and the current
channel.
Manufacturers’ codes for TV
RM–STHA75U
DVD CINEMA SYSTEM
CHANNEL/ZOOM VOLUME TV VOL
TUNING
STOP
DIMMER
PAUSE
FF/ /REW
TV/VIDEO 1 MUTING ¡
REC
PLAY
DOWN UP
MEMORY STROBE
DVD VCR 1
AUDIO ANGLE
FM/AM
SUBTITLE DECODE
RETURN DIGEST TOP MENU MENU
CONTROL EFFECT
S.WFR TEST
SLEEP
TV
VCR
SETTING
TV RETURN
ENTER
ON
SCREEN
CHOICE
FM MODE
1 2 3
4 5 6
7 8 9
10 0 +10
100+
TV AUDIO
VCR
SOUND
PTY SEARCH
SURROUND OFF DSP
CENTER –
+
–
+
–
+
–
+
SURR-L SURR-R S-BACK
–
+
ADJUST
O.T.
REPLAY
VFP
VCR/DBS
AUDIO/
TV/VCR
CATV/DBS
PROGRESSIVE
Set the remote
control mode
selector to
“AUDIO/TV/VCR.”
Manufacturer Code Manufacturer Code
JVC 01 Samsung 12
Hitachi 10 Sanyo 13
Magnavox 02 Sharp 06
Mitsubishi 03 Sony 07
Panasonic 04,11 Toshiba 08
RCA 05 Zenith 09
Operating other manufacturers’ video equipment
EN60-70.TH-A75[A]_f 02.11.7, 11:45 AM 62