JBL CVPD50 - Manual (Page 9)

9
Power Connection and Operator
Control
The CVPD50 plasma display and the
CVR700 are completely disconnected
from electrical power only when the
power cables are removed from both
units and/or the wall outlets, and the
JBL Digital Link
™ cable connecting the
CVR700 to CVPD50 is unplugged. Only
connect the CVPD50 plasma display and
the CVR700 to a plug receptacle that has
been installed in compliance with local
regulations regarding proper grounding,
and which provides 120V. Make sure that
the power plug and outlet are accessible
at all times.
Use only the power cord supplied with
the CVPD50 plasma display. Never
remove the plug from the outlet by
pulling on the cable. Do not run the
power cord near heat-producing objects.
If you will be away for an extended period
of time, it is a good idea to unplug the
units and any antennae. It is also a good
idea to do the same before any thunder-
storms. This is a precautionary measure
to prevent the possibility of personal
injury or death due to fire or electric
shock resulting from a lightning strike,
and to prevent damage to the unit.
Always power off all units and unplug
them before connecting them to each
other.
Failure to follow this instruction may
result in personal injury due to elec-
trical shock or fire, and/or irrepara-
ble damage to the unit that is not
covered under warranty.
The CVPD50 plasma display is equipped
with an attached glass filter plate. If the
unit is exposed to excessive stress, e.g.
due to shock, vibration, bending or heat,
the glass surface can break. Do not sub-
ject the glass surface to any pressure or
knocks. If the glass is cracked, unplug the
power cord immediately. Do not touch the
fragments with your bare hands. Failure
to follow these instructions may
result in personal injury due to
sharp-edged glass fragments.
Always make sure that two people lift
the CVPD50 plasma display together.
Never attempt to lift the unit by yourself.
Failure to follow this instruction may
result in personal injury or irrepara-
ble damage to the unit that is not
covered under warranty.
CVR700 OM 12/17/04 4:23 PM Page 9