Icom IC-208H - Manual (Page 65)

50
9
DTMF MEMORY ENCODER
9
■ Transmitting a DTMF code
D Automatic transmission (DTMF memory)
q Push [MONI•DTMF] for 1 sec. to turn the DTMF memory
encoder ON.
• “d” appears in place of 100 MHz digit.
w Push [SET•LOCK] to enter DTMF memory programming
condition.
e Rotate [DIAL] to select the desired DTMF memory chan-
nel.
r Push [PTT] to transmit the selected DTMF memory content.
t Push [MONI•DTMF] for 1 sec. to cancel the DTMF en-
coder.
• When the DTMF encoder is turned ON continuously, each push
of the PTT transmits the previously selected DTMF code.
z Push [FUNC] then [
LOW 6(DTMF)] to turn the
DTMF memory encoder ON.
• “d” appears in place of 100 MHz digit.
x Push [
SET B(D-OFF)] to enter the DTMF memory
programming condition.
c Push [Y] or [Z] to select the desired channel.
v Push [PTT] to transmit the selected memory.
• Exit the programming condition automatically.
• Each push of [PTT] transmits the DTMF code.
b Push [FUNC] then [
SET B(D-OFF)] to cancel the
DTMF memory encoder.
• When the DTMF encoder is turned ON continuously,
each push of the PTT transmits the previously se-
lected DTMF code.
D Transmitting a DTMF memory directly
z Push [FUNC] then [
LOW 6(DTMF)] to turn the
DTMF memory encoder ON.
• “d” appears in place of 100 MHz digit.
x Push [DTMF-S] to turn the DTMF memory di-
rect selection ON.
• The function indicator (microphone) lights green.
c Push the desired DTMF channel.
• “0” to “9” and “A” to “D” are available for DTMF
memory channels.
• The selected DTMF code is automatically transmit-
ted without pushing PTT.
NOTE: When no DTMF code programmed
channel number is pushed, it transmits the rela-
tive DTMF code as the manual transmission de-
scribed in the next page.
v Push [DTMF-S] again to deactivate the DTMF
memory direct selection.
b Push [FUNC] then [
SET B(D-OFF)] to cancel
the DTMF memory encoder.
DTMF-S
DTMF