Icom IC-208H - Manual (Page 60)

45
7
SCAN OPERATION
■ Scan resume condition
[
The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (p. 47)
q Push [SET•LOCK] to enter set mode.
w Push [SET•LOCK] or [S.MW•MW] several times until
“SCT” or “SCP” appears as shown above.
• When “d” is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 50)
e Rotate [DIAL] to set the desired timer:
• “SCT-15” : Scan pauses 15 sec. while receiving a signal.
• “SCT-10” : Scan pauses 10 sec. while receiving a signal.
• “SCT-5” : Scan pauses 5 sec. while receiving a signal.
• “SCP-2” : Scan pauses until the signal disappears and then
resumes 2 sec. later.
r Push [MONI•DTMF] to exit set mode.
z Push [BAND] to select the desired band.
x Push [
SET B(D-OFF)] to enter set mode.
c Push [
SET B(D-OFF)] or [ ENT C(T-OFF)] several
times until “SCT” or “SCP” appears as shown at
left.
v Push [Y] or [Z] to select the scan resume condi-
tion.
• See item r at left for scan resume condition details.
b Push [
CLR A(MW)] to exit set mode.
SET
B
The display shows that the
scan will resume 15 sec. after it
stops.