Icom IC-208H - Manual (Page 56)

41
7
SCAN OPERATION
■ Scan start/stop
D Preparation
Scan resume condition (p. 45); program the scan edges
(pgs. 42, 43); program 2 or more memory channels (pgs. 27,
28); set skip settings (p. 44), if desired.
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•PRIO].
• Select the desired bank for bank scan.
w Set the squelch to the point where noise is just muted.
e Push [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate [DIAL].
• The memory channel readout blinks the scan type as follows:
r Push [SET•LOCK] to switch full and programmed scan
(P1, P2, P3, P4 and P5), if VFO is selected in step q.
t To stop the scan, push [V/MHz•SCAN].
z Push [VFO/LOCK] to select VFO mode for
full/programmed scan; push [MR/CALL] to select
memory mode for memory scan.
• Push [FUNC] then [ MONI 1(BANK)] to select a bank
for bank scan.
x Push [
SQL Y D(MUTE)] or [ SQL Z #(16KEY-L)] to
set the squelch to the point where noise is just
muted.
c Push [
SCAN 2(T-SCAN)] to start the scan.
• Push [Y] or [Z] for 1 sec. also starts the scan.
v Push [
SET B(D-OFF)] to switch full and pro-
grammed scan (P1, P2, P3, P4 and P5), if VFO
is selected in step z.
b To stop the scan push [
SCAN 2(T-SCAN)] or
[ CLR A(MW)].
SCAN
2
SET
B
• During full scan • During programmed scan • During memory scan • During bank scan
Indicates scan edge channels.
• P1 stands for 1A/1B
• P1 to P5 are available when they
are programmed, and switches
with [SET•LOCK].
Indicates bank initial. Push [SET•LOCK] to select
“ALL” (full) or programmed scan
(P1, P2, P3, P4 and P5) in se-
quence.