Icom IC-208H - Manual (Page 52)

37
5
MEMORY OPERATION
■ Transferring bank contents
[
Contents of programmed memory banks can be cleared or
transferred to another bank.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain pro-
grammed.
q Select the desired bank contents to be transferred or
erased.
➥ Push [M/CALL•PRIO] several times to select memory
mode.
➥ Push [BAND] then rotate [DIAL] to select the desired
memory bank.
• Bank’s initial blinks.
➥ Push [BAND] to select the bank then rotate [DIAL] to se-
lect the desired contents.
• Bank’s initial stops blinking.
w Push [SET•LOCK].
e Push [SET•LOCK] or [S.MW•MW] several times until
“BAK” appears.
• The bank’s initial for the selected memory channel is displayed.
r Rotate [DIAL] to select the desired bank initial to transfer
or erase.
• Select “-- --” indication when erasing the contents from the bank.
t Push [V/MHz•PRIO] to set the bank and exit set mode.
y Repeat steps q to r for transferring or erasing an an-
other banks contents.
z Select the desired bank contents to be trans-
ferred or erased.
➥ Push [MR/CALL] to select memory mode.
➥ Push [FUNC], [
MONI 1(BANK)] then select
the desired memory bank via [Y]/[Z].
➥ Push [
CLR A(MW)] to select the bank then
select the desired contents via [Y]/[Z].
x Push [
SET
B(D-OFF)] to enter set mode.
c Push [
SET B(D-OFF)] or [ ENT C(T-OFF)] several
times until “BAK” appears.
v Push [Y]/[Z] to select the desired bank initial to
transfer or erase.
• Select “-- --” indication when erasing the contents
from the bank.
b Push [
CLR A(MW)] to set the bank and exit set
mode.
n Repeat steps z to b for transferring or eras-
ing an another banks contents.
BANK
[Y]/[Z]
SET
MAIN
T X
M