Icom IC-208H User Manual

Page 19

PANEL DESCRIPTION

rNARROW MODE INDICATOR (p. 65)

Appears when the FM/AM narrow mode is selected.
Narrow mode is available with USA version only.

tAM INDICATOR (p. 65)

Appears when AM mode is selected.

ySQUELCH ATTENUATOR INDICATOR (p. 16)

Appears when the squelch attenuator function is activated.

• The attenuator can be switched OFF in initial set mode. (p. 63)

uAUTO POWER-OFF INDICATOR (p. 62)

Appears while the auto power OFF function is in use.

iAUDIO MUTE INDICATOR (P. 18)

Appears when the audio mute function is activated.

• The mute can only be switched ON and OFF from the HM-133

only.

oFREQUENCY READOUT

Shows the operating frequency, channel names, set mode
contents, etc.

• Frequency decimal point blinks while scanning. (p. 41)
• “d” appears in place of the 1st digit while the DTMF memory

function is in use. (p. 48)

!0WEATHER ALERT INDICATOR (p. 66)

Appears when the weather alert function is activated.

• The either alert function is available with the USA version only.

!1PRIORITY INDICATOR (p. 47)

Appears while the priority watch is activated; blinks while
the watch is paused.

!2MEMORY CHANNEL NUMBER INDICATORS

➥ Shows the selected memory channel number. (p. 26)

➥ Shows the selected bank initial. (p. 35)

➥ “C” appears when the call channel is selected. (p. 38)

➥ “L” appears when the lock function is activated. (p. 14)

!3SKIP INDICATORS (p. 44)

➥ “~”appears when the displayed memory channel is

specified as a skip channel.

➥ “P ~” appears when the displayed frequency is spec-

ified as a program skip frequency.

!4MEMORY INDICATOR (pgs. 11, 26)

Appears when memory mode is selected.

!5S/RF INDICATORS

➥ Shows the relative signal strength while receiving sig-

nals. (p. 15)

➥ Shows the output power level while transmitting. (p. 17)

!6OUTPUT POWER INDICATORS

“LOW” appears when low output power; “MID” appears
when middle output power is selected.
No indicator appears when high output power is selected.

!7BUSY INDICATOR

➥ Appears when a signal is being received or the squelch

is open. (p. 15)

➥ Blinks while the monitor function is activated. (p. 15)