IBM EasyCoder 3400e - Manual (Page 94)

EasyCoder 3400e Bar Code Label Printer User’s Manual
6-14
5. Press the Feed/Pause button.
The printer prints out the software configuration label using the new X forms adjust
setting.
6. Verify the X forms adjust number on the software configuration label matches the
number you set in Step 4.
Y Forms Adjust
Use the Y Forms Adjust feature to control the position of the image in the direction
parallel to the printhead. See the Dot Increments DIP Switch Settings table on page 6-8
for information on how to move the image forward a number of dot increments. If your
label is too close to one edge of the printhead, you can adjust it using this feature.
To set the Y forms adjust
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning on the printer.
The printer prints out the hardware configuration label and then enters Data Line
Print mode.
3. In the top bank of the Test and Service DIP switches, turn on switches 1, 2, and 3.
4. In the bottom bank of the Test and Service DIP switches, turn on or off the
appropriate DIP switches. See the Dot Increments DIP Switch Settings table on
page 6-8 to see how to set the X forms adjust forward or backward a given number
of increments.
5. Press the Feed/Pause button. The printer prints out the software configuration label
using the new Y forms adjust setting.
6. Verify the Y forms adjust number on the software configuration label matches the
number you set in Step 4.