IBM EasyCoder 3400e - Manual (Page 90)

EasyCoder 3400e Bar Code Label Printer User’s Manual
6-10
To adjust the label rest point
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning on the printer.
The printer prints the hardware configuration test label and then enters Data Line
Print mode.
3. In the top bank of the Test and Service DIP switches, turn off switch 1 and turn on
switches 2 and 3.
To adjust the label rest point forward (feed more label), turn off DIP switch 4.
To adjust the label rest point backward (retract label), turn on DIP switch 4.
3XXXU.48
OFF
ON
1 2 3 4
Top Bank
Switch settings
for retracting label
1 2 3 4
Switch settings
for feeding
label forward
Top Bank
OFF
ON
4. In the bottom bank of the Test and Service DIP switches, turn on or off the
appropriate DIP switches. See the Dot Increments DIP Switch Settings table on
page 6-8.
5. Press the Feed/Pause button.
The printer prints the software configuration label and stops at the new location.
6. Verify that the label rest point number on the software configuration label matches
the number you set in Step 4.
7. Try printing again to see if you need to readjust the DIP switches in the bottom
bank.
8. If you need to readjust the DIP switches in the Bottom Bank, repeat Steps 4 through
7. If not, exit Test and Service mode by turning off the printer and returning all DIP
switches to their original settings.