beautypg.com

Cleaning the printhead – IBM EasyCoder 3400e User Manual

Page 56

background image

EasyCoder 3400e Bar Code Label Printer User’s Manual

HelvC

NugFont

C

39

3-6

Cleaning the Printhead

In order for the printhead to provide good print quality, it must maintain close contact
with the media. Therefore, cleaning media debris from the printhead is very important.
Clean after every roll [or 15,240 centimeters (6,000 inches)] of media or when
necessary.

Caution
Do not use sharp objects such as knives or screwdrivers to scrape the printhead
clean. Cleaning with sharp objects will damage the printhead. Clean with only a
cotton swab, or a clean, lint-free cloth or tissue damp with isopropyl alcohol.

Conseil
N’utilisez pas d’objets pointus tels que couteaux ou tournevis pour nettoyer la tête
d’imprimante. Nettoyer avec des objets pointus endommagera la tête d’imprimante.
Nettoyez-la seulement avec de la ouate ou avec un linge propre et libre de peluches,
humecté avec de l’alcool d’isopropyl.

To clean the printhead

1. Turn the On/Off switch to the off position and remove the power cord.

2. Remove the media cover.

3. Rotate the head lift lever clockwise until the printhead releases. Rotating the head

lift lever raises the printhead to allow for cleaning.

4. Remove the media and ribbon (if necessary).

5. Use a cotton swab moistened with alcohol to remove any dirt, adhesive, or debris

from the print surface on the bottom of the printhead.

6. Wait 5 to 10 seconds for the print surface to dry. Replace the media and ribbon.

7. Engage the printhead by rotating the head lift lever counterclockwise until it locks

in place.

8. If you are finished cleaning, replace the media cover.