IBM EasyCoder 3400e - Manual (Page 20)

EasyCoder 3400e Bar Code Label Printer User’s Manual
1-6
3. Plug the AC power cord into the receptacle at the rear of the printer. Plug the other
end of the power cord into a grounded wall outlet or surge protector.
4. Turn the On/Off switch to the on position. When you power on the printer, the
Power On LED lights, the Empty/Pause LED flashes, and the platen roller
advances. The yellow Empty/Pause LED then stays on steady because you have not
loaded media yet.
Opening the Printer
You need to open the printer every time you load media or perform maintenance
procedures.
To open the printer
1. Place the fingers of your right hand between the two notches on the lower edge of
the media cover (the media cover release) and pull the bottom of the media cover
away from the base of the printer.
2. Grasp the front of the media cover with your left hand and lift the front of the
media cover upward to release it from the printer frame.
3. Lift the media cover away from the top of the printer.
3XXXU.005
Po we r/D ata
34 00
Alert
Feed/Pause
Empty/Pause
Intermec Intermec
1
3
2