IBM EasyCoder 3400e - Manual (Page 86)

EasyCoder 3400e Bar Code Label Printer User’s Manual
6-6
Resetting the Memory on Your Printer
Use memory reset if you want to return your printer to its default configuration or if
you need to increase the amount of memory available in your printer. You can also use
memory reset to clear pages and formats, user-defined characters and fonts,
configurations, tables, or all of these parameters.
To use memory reset
1. Turn the printer off.
2. Press and hold the Feed/Pause button while turning on the printer. The printer
prints a hardware configuration test label.
3. Set the DIP switches to reset a portion or all of the memory by using the Test and
Service DIP Switch Settings table on page 6-4.
4. Hold the Feed/Pause button down for 1 second. The printer resets a portion or all of
its memory.
Setting Configuration Commands in Test and Service Mode
Test and Service mode also provides you with an alternative to using PrintSet or
sending configuration commands down from the host. You can change these
configuration commands by setting the Test and Service mode DIP switches:
•
Label rest point
•
86XX emulation
•
X forms adjust
•
Y forms adjust
The following table provides you with the Test and Service mode DIP switch settings
for changing the configuration commands.