Printing the hardware configuration test label, Nugfont, Getting started 1-9 – IBM EasyCoder 3400e User Manual
Page 23
HelvC
NugFont
C
39
Getting Started
1-9
1
Printing the Hardware Configuration Test Label
You can print the hardware configuration test label to test the printer and make sure it is
operating correctly. The hardware configuration test label lists the printer’s
configuration. Use this label for reference when installing your printer and for
verification of proper printer operation.
To print the hardware configuration test label
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while you turn the On/Off switch to the on
position. The Alert and Empty/Pause LEDs blink during the printer self-test.
3. Release the Feed/Pause button when the media starts moving. The printer feeds out
one or two blank labels and then prints the hardware configuration test label.
4. Turn the printer power off and then on. You are now ready to connect your 3400e
printer to your system.
Hardware Configuration Test Label
3XXXU.007
3400e400 Hardware Configuration
: 128 kilobytes
: 805 kilobytes
: OKB
: 0
: 0
: 0
: 1792
: 2.5
: 141
: none
: none
: Cutter
: 95D0
: 7331
: 067097
: 2.0
Memory Installed
Flash Storage
Image RAM
Flash SIMM
Mileage
Inches Processed
Inches Burned
Labels Cut
Printhead
Width
Dot Size
Burn Pot Setting
Hardware Options
I/O Option
Internal Option
External Option
Firmware Checksum
ROM0 (U21)
ROM1 (U9)
Program
Version
Note: This is only an example of a hardware configuration label. Your label may not be
exactly the same.