Invacare Top End X-Terminator QR - Manual (Page 71)

SECTION 8—SUSPENSION
Part No 1114851 71 Everyday and Sport Series Wheelchairs
FIGURE 8.1 Replacing Rear Elastomers
Replacing Front Elastomers
CAUTION
DO NOT use excessive force when removing/installing the threaded sleeve
from/onto the fork. Damage to the threaded sleeve may occur.
NOTE: For this procedure, refer to FIGURE 8.2.
1. Using two allen wrenches, turn in opposite directions and remove one mounting
screw from fork.
NOTE: One mounting screw will not turn.
2. Remove the threaded sleeve and mounting screw assembly from the fork. DO NOT
use excessive force.
3. Remove the existing elastomer from the fork.
4. Install NEW elastomer determined in STEP 1 into fork.
NOTE: Make sure the elastomer sits in the two recessed areas on the fork.
5. Align the mounting holes in the upper and lower portion of the fork.
6. Reinstall threaded sleeve and mounting screw assembly. DO NOT use excessive force.
Outside of
Wheelchair Frame
Inside of Wheelchair Frame
Suspension Base
Mounting
Holes
Axle Bracket
Inner Allen
Screw
Recess
Elstaomer
Pivot Pin
Recess
Outer Allen
Screw