Adjusting toe in/toe out, Camber tube 2000, Figure 5.8 – Invacare Top End X-Terminator QR User Manual
Page 43: Figure 5.8)
SECTION 5—WHEELS
43
Everyday and Sport Series Wheelchairs
FIGURE 5.8 Determining Toe In/Toe Out - Measuring Centerlines of Rear Wheels
Adjusting Toe In/Toe Out
Camber Tube 2000
NOTE: For this procedure, refer to FIGURE 5.9.
1. Open the camber clamps. Refer to Opening/Closing Camber Clamps on page 39.
2. Slowly rotate the camber tube in either direction until the rear wheels are
approximately in a straight line.
3. Close the camber clamps. Refer to
Opening/Closing Camber Clamps on
page 39.
4. Measure the distance between the
center lines at the rear and front of the
rear wheels at approximately 12 inches
from the ground/floor. Refer to
Determining Toe In/Toe Out on
page 42.
5. Repeat STEPS 1‐4 until the toe in/toe
out measurement is less than 1/2‐inch
(0 + 1/4‐inch for maximum rollability).
FIGURE 5.9 Adjusting Toe In/Toe Out -
Front of Wheelchair
12-inches
Rear of
Wheelchair
Centerlines of Rear Wheels
Front of Wheelchair
Top View of Wheelchair
Smaller than
Front
Larger than Front
Toe-out
Toe-in
Top View of Wheelchair
Camber Tube - Rotates Up and Down
Camber Clamps