Adjusting footplate angle, Adjusting footplate depth, Installing the x-terminator footrest – Invacare Top End X-Terminator QR User Manual

Page 64: Figure 7.3, Refer to adjusting footplate angle on

SECTION 7—FOOTREST/ ANTI-TIPPER

FIGURE 7.3 Replacing/Adjusting Optional A4 Footrest

Adjusting Footplate Angle

1. Loosen, but DO NOT remove the four flat screws and locknuts that secure the

footplate to the two footrest tubes.

2. Position the footplate to the necessary angle to accommodate the user.

3. Retighten the four flat screws and locknuts.

NOTE: The locknuts should lie in the channel of the footplate half clamp.

Adjusting Footplate Depth

1. Loosen, but DO NOT remove the four flat screws and locknuts that secure footplate

to the footrest tubes.

NOTE: Observe the angle of footplate for reinstallation.

2. Move the footplate to one of two positions to accommodate the user.

3. Retighten the four flat screws and locknuts.

NOTE: The settings for positioning the footplates on the half‐clamps may vary for each end user.

NOTE: The locknuts should lie in the channel of the footplate half clamp.

Installing the X-Terminator Footrest

NOTE: For this procedure, refer to FIGURE 7.4.

1. Install the two half clamps onto either side of the wheelchair frame approximately 2

inches above the existing footrest with two provided allen screws.

2. Repeat for the opposite side of the wheelchair.

3. Slide the clamp on raised footrest into the half clamps to the desired height.

4. Securely tighten the four allen screws.

Allen Screws

Footrest

Tube

Flat

Screws

Footplate

Flat Screws

Angle

Depth

Height

This manual is related to the following products: