Invacare JYMNI 9000 - Manual

Part No. 1058751 1 9000 Series and Jymni™ Anti-tippers
SAFETY SUMMARY
To ensure the safe installation and use of the Anti-tippers, these instructions
MUST be followed:
WARNING
Do not operate this equipment without first reading and understanding this
instruction sheet and the owner's manual, part number 1056953, for the
9000 series wheelchairs or the owner's manual, part number 1100868, for
Jymni wheelchairs. If you are unable to understand the warnings, cautions,
and instructions, contact a healthcare professional, dealer or a qualified
technician before attempting to use this equipment - otherwise injury or
damage may result.
Anti-tippers are specific to the different seat-to-floor angles and/or seat-to-floor
heights. Refer to the chart in this instruction sheet for correct usage and
adjustment. If these requirements CANNOT be achieved, DO NOT use the
wheelchair. Contact a qualified technician. If changing the seat-to-floor height
with or without a change to seat-to-floor angle, the correct anti-tippers MUST be
used to maintain a 1-1/2 to 2-inch ground clearance.
9000 WHEELCHAIRS WITH A SEAT-TO-FLOOR ANGLE OF 0°
OR 3° AND
JYMNI NON-RECLINERS ONLY - If so equipped, anti-tippers MUST be
attached at all times. Inasmuch as the anti-tippers are an option for 0° or 3° on
this wheelchair (You may order with or without the anti-tippers), Invacare
strongly recommends ordering the anti-tippers as a safeguard for the wheelchair
user.
9000 WHEELCHAIRS WITH A SEAT-TO-FLOOR ANGLE OF 6° ONLY - If
changing the seat-to-floor angle to 6°, anti-tippers MUST BE ORDERED AND
INSTALLED.
JYMNI RECLINERS AND JYMNI WHEELCHAIRS WITH 1-INCH
FORWARD REAR WHEEL POSITIONERS ONLY - Anti-tippers MUST
be attached at all times.
Anti-tippers MUST be fully engaged and spring buttons fully protruding
out of adjustment holes, BEFORE using the wheelchair.
Ensure both anti-tippers are adjusted to the same mounting hole.
Anti-tipper kits include the following parts:
Description Quantity Description Quantity
Anti-tipper 2 Anti-rattle 2
9000 Series and Jymni™ Anti-tippers
Assembly, Installation and Operating Instructions
Adjustable Anti-tipper Kit Nos. 1058752, 1058836, 1064520 and 1101960
Non-adjustable Anti-tipper Kit Nos. 1113764, 1113765 and 1113766
NOTE: Check all parts for shipping damage before using. In case of damage, DO NOT use.
Contact the dealer/carrier for further instructions.
SAVE THESE INSTRUCTIONS