Adjusting quad-release handles, In and/or out, Removing play from rear wheels – Invacare Top End X-Terminator QR User Manual
Page 37
SECTION 5—WHEELS
37
Everyday and Sport Series Wheelchairs
7. If detent pin does not fully release, proceed to Adjusting Quad‐Release Handles on
8. Repeat STEPS 1‐7 for the opposite rear wheel.
Adjusting Quad-Release Handles
NOTE: For this procedure, refer to FIGURE 5.4.
In and/or Out
1. Remove rear wheel and the
quad‐release axle from the wheelchair.
Refer to Removing/Installing Rear
Wheels on page 35.
2. Loosen the locking screw.
3. Make one or both of the following
adjustments:
• If the quad‐release handle is not
releasing the locking pins
completely, rotate the quad‐release
handle approximately one‐quarter
turn clockwise.
• If the quad‐release handle hits the
spokes of the rear wheel when
assembled, rotate the quad‐release
handle approximately one‐quarter
turn counterclockwise.
4. Tighten the locking screw.
FIGURE 5.4 Adjusting Quad-Release
5. Reinstall the rear wheel and quad‐release axle onto the wheelchair. Refer to
Removing/Installing Rear Wheels on page 35.
6. Flip the handle of the quad‐release axle down to release the detent pin ensuring that
the locking pins are fully released.
7. Repeat the above procedures until the quad‐release axle locks correctly.
Removing Play from Rear Wheels
1. With the rear wheel and quad‐release axle still mounted onto the wheelchair, make the
following adjustment:
• Tighten the length adjusting screw until there is no in and out movement of the
quad‐release axle and rear wheel.
Adjusting Locknut
(On Quick-Release Axle)
Length
Adjustment
Screw
Removing
Play from
Rear Wheels
Adjusting Quad-Release
Handle In and/or Out
Locking Pins
Camber Bar
Locking
Screw
Quad Release
Handle