Milwaukee LSM40MP-2 - Manual (Page 28)

28
Glass Door
Assembly
Fireplace
Finish Combustible
Or Non-Combustible
Material
Bottom Of
Fireplace
1/8 Inch
Minimum
Door Track
Finish Combustible
Or Non-Combustible
Material
Front Face
Of Fireplace Floor Panel
Figure 55
Figure 54
Non-combustible.materials,.such.as.surrounds.and.other.appliance.trim,.
may.be.installed.on.the.appliance.front.face.with.the.exceptions..
Vertical.installation.clearances.to.combustible.mantels.vary.according.
to.the.depth.of.the.mantel...See.Figure 9...Mantels.constructed.of.non-
combustible.materials.may.be.installed.at.any.height.above.the.appliance.
opening.
Combustible.materials.may.project.beyond.the.side.of.the.fireplace.opening.
as.long.as.it.is.kept.within.the.shaded.area.illustrated.in.Figure 10.
* Insulation is NOT ALLOWED in the clearance zones around vent
components. Keep this area free from combustible materials.
2 Foot Vertical
Vent & 90° Elbow
3" Min.
(76 mm)*
Top of
Appliance
8-3/8" Min.
(213 mm)
Combustible
materials are
allowed above
this point on
the face of the
appliance.
The gray shaded
area must be
non-combustible
or Dura Rock
Header
(2x4’s)
Spacers
Top of Door Frame
Fireplace (right side)
Combustible
Finished Wall
Materials
1 *
Installations with horizontal terminations which have minimum
vertical vent height only will require 4”(102mm) minimum
side clearance as shown in shaded zone above. All other
installations require 1" (25mm) minimum side clearance as
specified in Table 4 on Page 5.
1
Figure 53
FINISHING REQUIREMENTS
Wall Details
Complete.finished.interior.wall..To.install.the.appliance.facing.flush.with.
the.finished.wall,.position.framework.to.accommodate.the.thickness.of.
the.finished.wall.(Figure 53).
A.hearth.extension.is.not.required.with.this.appliance..If.a.hearth.extension.
is.used,.there.are.two.methods.of.installation...One,.the.finish.combustible.
or.non-combustible.material.could.be.ended.by.butting.up.against.the.
front.face.of.the.fireplace.and.the.floor.panel.(refer to Figure 54).
Two,.the.finish.combustible.or.non-combustible.material.could.be.ended.
below.the.fireplace (refer to Figure 55)...Remove.the.floor.panel.as.shown.
in.Figure 54.by.removing.the.screws.on.the.right.side.of.the.panel.and.
sliding.the.left.side.away.from.the.tab...Discard.the.screws.and.floor.panel...
It is critical that there is at least a 1/8" gap between the bottom of the
door track and the surface of the finish material.