Milwaukee LSM40MP-2 - Manual (Page 24)

24
NOTE:.DIAGRAMS.&.ILLUSTRATIONS.ARE.NOT.TO.SCALE.
Step 1.. Install.the.ceramic.panels.per.the.instructions.provided.in.kit.
(reference form #750182M).
Step 2.. Place.a.mixture.of.volcanic.stone.and.vermiculite.around.the.
burner.as.shown.in.Figure 43.
Step 3...Separate.the.glowing.embers.(rockwool).into.pieces.about.the.
size.of.a.quarter.(see.Figure 41)...Keep.the.pieces.fluffed,.not.
matted...Distribute.these.pieces.over.the.burner.as.shown.in.
Figure 42...Do.not.use.more.than.necessary...When.properly.
positioned,.the.Glowing.Embers.will.cover.approximately.75%.
of.the.burner.on.natural.gas...For.propane.gas,.do.not.place.
embers.on.main.ports.
Note: Excessive use of embers may result in sooting or poor flame.
This appliance is provided with enough Glowing Embers for several
applications, do not feel compelled to use all that is in a new bag. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (Catalog Number 88L53).
Step 4...Position.the.individual.logs.as.shown.in.Figures 44 through 48...
Logs.should.be.placed.in.the.order.shown...Place logs 2 and 3
against the pins on the grate, NOT over them.
. Proper.log.and.twig.placement.is.critical.to.encourage.outstand-
ing.flame.appearance.and.prevent.sooting...When.positioned.
properly. as. shown,. twigs. will. be. positioned. between. flame.
peaks.and.will.not.impinge.any.flames...Positioning.is.the.same.
for.all.colors.of.log.sets.
Figure 41
Figure 42
Glowing Embers (Rockwool)
For Propane Gas Only, Do Not Place Embers On Main Ports
Figure 43 - (LSM45-2 Shown)
Mixture Of Volcanic Stone And Vermiculite
WARNING
• DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• The size and position of the log set was engi-
neered to give the appliance a safe, reliable
and attractive flame pattern. Any attempt to use
a different log set in the fireplace will void the
warranty and will result in incomplete combus-
tion, sooting, and poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to
the appliance before you install grate, volcanic
stone, vermiculite, embers and logs.
• This appliance is not designed to burn wood.
Any attempt to do so could cause irreparable
damage to the appliance and prove hazardous
to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
Step 8. LOG, VERMICULITE, VOLCANIC STONE AND GLOWING
EMBER PLACEMENT
REFERENCE - Firebox Accessories / Parts
Cat. No. Model Description
88L53 FGE Bag of Glowing Embers
80L42 FDVS Bag of Volcanic Stone
H6319 Bag of Vermiculite