Caution, Warning – Milwaukee LSM40MP-2 User Manual

Page 27

NOTE:.DIAGRAMS.&.ILLUSTRATIONS.ARE.NOT.TO.SCALE.

Figure 52 - Burner Flame Appearance

(Rustic Oak Logs Shown) LSM45-2

Figure 51 - Burner Flame Appearance

(Birch Logs Shown) LSM40-2

To.adjust.the.flame,.rotate.the.air.shutter.toward.

the.back.or.toward.the.front.of.the.fireplace..

Position.the.air.shutter.to.the.factory.setting.as.

shown.in.the.table.in.

Figure 50...Allow.the.burner.

to.operate.for.at.least.15.minutes...Observe.the.

flame.continuously..If.it.appears.weak.or.sooty.

as.previously.described,.adjust.the.air.shutter.

until.the.flame.appearance.is.as.desired..

Use the extension knob (refer to Figure 38), to

adjust the flame height as desired, by sliding

the knob over the variable flame adjustment

knob located on the front of the valve. Replace

the extension knob back to the hanger after

the adjustment.

Propane.models.may.exhibit.a.flame.pattern.

that. may. candle. or. appear. stringy.. If. this. is.

problematic. or. persists. as. the. appliance. is.

continually. operated,. adjust. the. air. shutter.

closed.as.described.in.the.previous.paragraphs..

Operate.the.appliance.for.a.period.of.time.as.the.

effect.diminishes,.ensuring.that.the.appliance.

does.not.develop.sooty.flames...When.satisfied.

that.the.appliance.operates.properly,.proceed.

to.finish.the.installation.

Leave.the.control.knob.in.the.ON.position.and.

the.remote.switch.OFF.

CAUTION

Soot will be produced if the air

shutter is closed too much. Any

damage due to carboning result-

ing from improperly setting the

air shutter is not covered under

the warranty.

Air Shutter

Opening

Burner

Orifice

Gas

Valve

Venturi

Main Burner Factory Air Shutter

Opening Setting - Inches (millimeter)

Model

Nat.Gas

Propane Gas

LSM40-2

1/16 (1.59)

9/32 (7.14)

LSM45-2

1/16 (1.59)

9/32 (7.14)

Figure 50

WARNING

•

Air shutter adjustment should

only be performed by a quali-

fied professional service

technician.

•

Ensure that the front glass

door assembly is in place and

sealed After adjustment.

Burner Air Shutter Adjustment Procedure