Miller Electric Welder - Manual (Page 119)

OM-196 188 Page 113
14-10. Selecting Wire Type
If wire type is changed, perform a system reset (see Section 14-12) immediately
after selecting wire type to bring up the correct welding programs.
NOTE
1 Wire Type Display
Select soft wire when using
aluminum wire in the wire feeder.
Select hard wire when using any
other kind of wire.
Wire Type
> Hardwire
System
Reset
Now
1
Arc Time
Wire feed
> Wiretype
Display
Wire Type
> Softwire
System
Reset
Now
Press Mode
Select
Increase
Access
Setup
Display
.
After using system reset to store wire type selection into
memory, all other setup parameters return to factory default
settings. See Section 14-2 for procedure to return to setup
displays and reset parameters.
1 Display Select Display
The display can show amps, actual
reading or print out command.
1
Wirefeed
Wiretype
> Display
Memory
> Command
> Amps
> Actual
14-11. Defining Display Value
Press Mode
Select
Increase
Access
Setup
Display
Increase