Miller Electric Welder - Manual (Page 110)

OM-196 188 Page 104
13-4. Reading From Card
Programs developed on the Auto Invision will not run the same on Auto Invision II.
NOTE
Use Mode Select button to select Card.
1
Card Display
2 Moving Line
Moving line is under value that can be
changed. Use increase or decrease button
to select program number to read from card
to feeder.
3 Read Display
Use increase or decrease button to select
feeder program number where the card pro-
gram goes.
Process
Sequence
SharpArc
> Card
Press
Below
# 1 Pulse
035” Steel
Argon – Oxy
Press
1
2
3
Read Card
to Feeder
Prg 1
Press
WARNING: Prg1 Will
Be Lost
Lose? Yes
Press Prg1 Will
Be Lost
Lose? No
Press
Read Done
Card Prg1
to Prg 1
Press
#1 Pulse
035” Steel
Argon – Oxy
Press
# 1 Pulse
035” Steel
Argon – Oxy
Press
Write
> Read
Delete
Done
Mode
Select
Twice
Parameter
Select
Increase
Parameter
Select Once
Parameter
Select
Parameter
Select
Parameter
Select
Parameter
Select
No
Yes