Motorola SYMBOL MINISCAN MSXX04 - Manual (Page 49)

Scanning 3 - 7
Beeper and LED Definitions
Table 3-1 provides beeper definitions, and Table 3-2 provides LED definitions.
Table 3-1 Beeper Definitions
Beeper Sequence Indication
Standard Use
1 Beep - short high tone A bar code symbol was decoded (if decode beeper is enabled).
1 Beep - long high tone Thermal shutdown.
3 Beeps - short high tone
(MS2204/2204VHD/3204 only)
Power-on or reset. Occurs immediately after the scanner is turned on,
indicating that the system software is working properly. If three beeps occur
during normal operation, it is due to a reset and any work in progress is lost. If
this occurs often, contact Motorola Enterprise Mobility Support.
Parameter Menu Scanning
2 Beeps - short high tone Correct entry scanned or correct menu sequence performed.
1 Beep - hi/lo/hi/lo tone Successful program exit with change in the parameter setting.
2 Beeps - lo/hi tone Input error, incorrect bar code, or Cancel scanned, wrong entry, incorrect bar
code programming sequence; remain in program mode.
Communication
4 Beeps - short high tone Communication error.
4 Beeps - hi/hi/hi/lo Receive error.
3 Beeps - lo/hi/lo ADF transmit error.
Table 3-2 LED Definitions
LED Indication
Red Scanner is on.
Green A bar code was successfully decoded.