Event reporting, Decode event, Event reporting -99 – Motorola SYMBOL MINISCAN MSXX04 User Manual
Page 205: Decode event -99, Decode event parameter # f0h 00h
Parameter Menus 10 - 99
Event Reporting
The host can request the decoder to provide certain information (events) relative to the decoder’s behavior. Enable
or disable the events listed in
by scanning the appropriate bar codes on the following pages. Parameter
number format for these parameters follows those shown in the Simple Serial Interface (SSI) Programmer’s Guide
for parameters numbered 256 or higher.
Decode Event
Parameter # F0h 00h
When enabled, the scanner sends a message to the host whenever a bar code is successfully decoded. When
disabled, no message is sent.
Enable
(01h)
*Disable
(00h)
Table 10-3
Event Codes
Event Class
Event
Code Reported
Decode Event
Non parameter decode
01h
Boot Up Event
System power-up
03h
Parameter Event
Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
07h
08h
0Ah
0Fh