User-programmable supplementals, Decode upc/ean supplemental redundancy, Set via – Motorola SYMBOL MINISCAN MSXX04 User Manual
Page 140: Decode upc/ean, User-programmable supplementals on, User-programmable
10 - 34 Symbol MiniScan MSXX04 Series Integration Guide
User-Programmable Supplementals
Supplemental 1: Parameter # F1h 43h
Supplemental 2: Parameter # F1h 44h
If you selected a Supplemental User-Programmable option from
Decode UPC/EAN Supplementals on page 10-30
select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the numeric
bar codes beginning on
Select User-Programmable Supplemental 2 to set a second 3-digit prefix.
Then select the 3 digits using the numeric bar codes beginning on
User-Programmable Supplemental 1
User-Programmable Supplemental 2
Decode UPC/EAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times (from 2 to 30) a
symbol without supplementals is decoded before transmission. Five or above is recommended when decoding a
mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two numeric bar codes beginning on
. Enter a leading zero for single digit numbers. To change the selection or to cancel an incorrect entry,
bar code on
.
Decode UPC/EAN
Supplemental Redundancy
NOTE
The default supplemental redundancy for Symbol MS954 is 7.