Motorola SYMBOL MINISCAN MSXX04 - Manual (Page 202)

10 - 96 Symbol MiniScan MSXX04 Series Integration Guide
Host RTS Line State
Parameter # 9Ah
This parameter is used to set the idle state of the Serial Host RTS line.
The SSI Interface is intended to be used with host applications which also implement the SSI protocol. However,
the scanner can be used in a "scan-and-transmit" mode to communicate with any standard serial communications
software on a host PC (see
Decode Data Packet Format on page 10-97 ). If transmission errors occur in this mode,
the host PC may be asserting hardware handshaking lines which interfere with the SSI protocol. Scan the HOST:
RTS HIGH bar code to address this problem.
*Host: RTS Low
(00h)
Host: RTS High
(01h)
NOTE This option is supported by the MS1204FZY, MS2204, MS2204VHD and MS3204 only.