Motorola SYMBOL MINISCAN MSXX04 - Manual (Page 28)

2 - 4 Symbol MiniScan MSXX04 Series Integration Guide
Mounting the Scanner on the Stand
To mount the scanner on the optional stand:
1. Place the bottom of the scanner on the stand’s scanner mount, aligning the scanner’s center threaded insert
(beneath the scan window) with the center mounting hole on the front of the stand. The two rear threaded
inserts on the bottom of the scanner will align with the proper mounting holes on the stand.
2. Secure the scanner to the stand using the three screws provided with the stand.
Assembling the Stand
Figure 2-4 Assembling the Stand
NOTE The stand is optional for the Symbol MS1204FZY, MS2204, MS2204VHD, and MS3204 only.
Stand base
Wingnut
1. Unscrew the wingnut
from the bottom of the
one-piece scanner
mount.
2. Fit the bottom of the
neck piece into the
opening on the top of the
stand base.
3. Tighten the wingnut
underneath the base to
secure the cup and neck
piece (see the note
below).
4. Bend the neck to the
desired position for
scanning.
Scanner mount
Flat areas
Mounting holes
NOTE Before tightening the wingnut under the base, ensure that the flat areas on the flexible neck fit securely in
the grooves in the base.