Motorola SABER RVN4002K - Manual (Page 86)

H702 - Two-Tone Group Call
To select this option you must select the Quik-Call II option. This option can offer Individual call
together with Two Tone Group call. When this option is selected the pop-up window will be
displayed on the screen to get two different frequencies for individual call and two different
frequencies for two-tone group call. Tone A frequency must be different from tone B frequency.
The valid range of the Quik Call II frequency is from 288.5 Hz to 2469 Hz. This option is
incompatible with the following options:
H701 - Individual
Call
H703 - Long Tone B Group Call
H703 - Long Tone B Group Call
To select this option you must select the Quik Call II
option. This option can offer Individual call along with Long Tone B Group call option. The
Individual calls are determined by two sequential tones, tone A and tone B. Remember that tone
A cannot be equal to tone B. When this option is selected the pop-up window is displayed on
the screen to get two different frequencies for individual call and one tone B frequency for long
tone B group call. The valid range of the Quik Call II frequency is from 288.5 Hz to 2469 Hz. This
option is incompatible with the following options:
H701
- Individual Call
H702 - Two-Tone Group Call
H167 - Timed Auto Reset
To select this option you must select the Quik Call II option. This option allows you to enter the
time after which the radio goes back to Quik Call decode mode (i.e., after decoding Quik Call in
the Quik Call decode mode). In addition, transmitting while in the Quik Call decode mode resets
the timer at the end of the transmission. The valid range is 1 - 290 seconds ( a default of 5
seconds is set if this option is selected). This option will be selected automatically if option H188
is selected. If this option is not selected, the radio will be in manual reset mode : you can
manually force a reset by momentarily depressing the monitor button.
H188 - Carrier Override Timed Auto Reset
To select this option you must select the Quik Call II option. This option is used in conjunction
with option H167 (Timed Auto Reset). You can enter a value ranging from 1 to 290 seconds ( a
default of 5 seconds is set if this option is selected), in case option H167 is not already selected.
If you select this option, the timer is reset at the end of the carrier. This is in addition to the
characteristics described for H167.
Singletones - General (PTT/RATs)
This is the most flexible option out of all the three single tone options. When selecting this option
,two windows will pop-up in sequence. Enter a frequency in each of these pop-up windows.
Both of these tones can be transmitted through any of the three transmit switches
(PTT/RAT1/RAT2). The valid range for these two frequencies is from 300 Hz to 3000 Hz in
increments of 1 Hz. This option is a non-numbered option.This option is incompatible with the
following options.
H707 -
1 Tone Singletone via PTT Button
H742 - 2 Tone Singletones via RAT Buttons
The following options are enabled if you select this option :
Singletone Non-Std. Pretime
Singletone Time Duration
H619 -Omit MDC Side Tones
80 Appendix - 5. Options List and Definitions