Motorola SABER RVN4002K - Manual (Page 16)

B. Optional Hardware Requirements
Additional hardware will be required if it is necessary to read, program, or align a SABER radio.
The following section provides a list of required hardware.
Only one of the two cables is required. Choose the appropriate one for your machine.
- Computer Interface Cable ( 25-pin connector cable ): #30-80369B71
- Computer Interface Cable ( 9-pin connector cable ): #30-80369B72
Radio Interface Box ( RIB ): #RLN-4008A
RIB Power Supply: #01-80357A57 (110V)
#01-80358A56 (220V)
#60-82728J01 (9V)
Programming Cable: #RTK-4203A
For Alignment: ( See items listed in your SABER Service Manual)
- Power Meter
- RF Monitor
- Frequency Generator (10 Hz - 10 kHz)
- Battery Eliminator: #RTL-4224A
- Portable Products Test Set: #RTX-4005B
C. Connecting The Radio To The Computer
The SABER radio and the Radio Interface Box (RIB) should be connected to the computer as
described below. Refer to Figure 4.
Figure 4. Connecting the Radio to the Computer
RIB
15-Pin
RLN-4008
25-Pin
Radio Interface Box
DOS 3.1
RS-232 Port
512k RAM
Computer Interface Cable
P/N: 30-80369B71
or B72
To COM 1 or COM2
SABER
RADIO
Program/Test Cable
RTK-4203A
640k
10 Hardware Installation