Motorola SABER RVN4002K - Manual (Page 83)

Designated Transmit Mode
This option will force you to transmit on a specific channel anytime the PTT is pressed while
scanning regardless of what state the scanner is in. The designated transmit channel will be
specified per scan list. If this option is selected along with floating priority, the floating priority
channel will always be the designated transmit channel since this is always the channel of
transmission. If you do not select this option then for each scan list, transmit channel will always
be the channel on which the radio was when scan was entered.
Priority to Follow Channel Selector Switch
Selecting this option will assign priority channel 1 to the position of the channel selector switch.
For example, if you are on channel 5 then your priority channel 1 is assigned to channel 5. If you
change the position of the channel selector switch while scanning, the radio will exit the scan
mode. The channel selected to be the priority channel must be chosen before activating scan.
Autoscan
This option modifies the behavior of mode-slaved scan (H344) such that, when a channel is
selected on the radio, scanning will begin immediately if there is a scan list assigned to that
channel. This feature is only available in zone/channel radios, and is not compatible with
operator-selectable scan.
Required options: H344, H371, H669
Incompatible options: H396, H397, H273, and Nuisance Delete
Mode Slaved Scan (for SABER II.2)
This option is available only in SABER II.2 radios. It allows only 2 scan lists. Selecting this
option will give you 2 scan lists with 13 entries per scan list. The 13 entries include: 2 priority
channels, 10 non-priority channels, and 1 optional entry for the designated transmit channel.
The two priority channels will be scanned more often than the non-priority channels and will
continue to be scanned even if a lower priority channel is currently being monitored. If both
priority channels are used, the channel with priority 1 status will override a priority 2 channel such
that the priority 1 channel will continue to be scanned even if the priority 2 channel is active. In
any scan list it will be possible to omit either or both of the priority channels. With this option you
can only have 3 zones/36 channels (see option H371 - zone and channel operation). The
nuisance mode delete option, scroll scan list option, and autoscan are not available with this
option.
H444 - Delete Proper Code Detect
If this option is enabled the radio will mute on any signal. If a coded signal with different key is
present the radio will unmute with encrypted data which will sound like noise to the user.
H245 - Delete Clear Mode Alert Tones on Transmit
This option will delete the alert tone that is used to indicate that the radio is transmitting in the
clear mode. The frequency of this tone is 820 Hz for a duration of 80 ms. You can only mute this
tone using the Radio Service Software.
H244 - Delete Clear Coded Transmit Switch
If your radio is SECURE and does not have a coded/clear selector switch, you must enable this
option; otherwise, you may electronically disable this option. If your radio is not a SECURE radio
you will not even see this option on the screen.This option is incompatible with option H400 -
Secure Voice Slaved to a Mode, when selected all channels are assumed to be "coded."
Appendix - 5. Options List and Definitions 77