Motorola SABER RVN4002K - Manual (Page 46)

Figure 15. Write Data to Radio
When programming is complete, the RSS will revert to the "READ/PROGRAM" menu, the
radio will automatically reset, and the radio display will clear. If the display still shows an
"ERR X YZ" message after programming is complete, try reprogramming the radio. If the
error condition persists, contact your Motorola service representative, or see Appendix-1 for
a description of the error code.
Extraction:
The extraction feature enables you to easily change personalities in a radio without having to
realign the radio. During the extraction process, the RSS reads all the alignment data from
the radio to be programmed. This alignment data is then applied to the current radio
personality, which is then converted to codeplug(s) and written to the radio in the normal way.
In order to better understand the extraction process, an explanation of the normal alignment
process is necessary. First, assume that you have just created a new radio personality. The
RSS, not knowing what radio the personality is destined to occupy, inserts "default"
alignment values into the personality. These default values are necessary to ensure that a
radio will function when programmed with the personality. Next, assume that you must put
this personality into a radio that has never been aligned. You will write the personality to the
radio and, when prompted, select "F2 - Use Programmer Tuning Values." This is necessary
because the radio has never been aligned, and there are no existing alignment values to
extract from the radio.
40 Get/Save/Program Codeplug Data
F1 F4 F2 F3 F5 F6 F7 F8 F9 F10
MOTOROLA Radio Service Software
SABER Model:
Ver. R05.00.00
Main.Get/Save/Prog.Read/Prog.Program
WRITE DATA TO A RADIO
The RPF file conversion is complete.
0% 100%
................................................
................................................
................................................ Programming COPE Internal
Programming COPE External
Programming CORE 6d
Accessing Serial Bus.
R07.01.00
0% 100%
6D