MITSUBISHI ELECTRIC DX-NT400E - Manual (Page 6)

6
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Flowchart
■ Flowchart for connection and settings
Installation example:
Connect the terminals on the rear panel; and set the initial settings. Next, make an alarm recording using the timer
function, using alarm list search, and playback the searched data.
Connections
• Connect the terminals on the rear panel.
See “ ■ Connecting to CCTV camera, monitor, and sensor” on page 12.
• Connection for the alarm recording.
See “ ■ Alarm recording connection” on page 13, and “ ■ Rear view” on page 9.
• Connect the supplied wired remote control (R-400).
See “ ■ Connecting the wired remote control R-400 (supplied)” on page 13.
Attaching the HDD
• Attach the HDD to this unit.
See “ ■ Attaching and Removing the HDD to the DX-NT400E” on pages 14 to 17.
Setting up the unit
• Test the HDD attached to the unit.
See “ ■ HDD SELF TEST” on pages 18 and 19.
• Set up the unit using menu.
See “ ■ AUTO SET UP” on pages 20 and 21.
The unit boots-up.
Changing the initial menu settings
• Select the language.
See “ ■ LANGUAGE SELECTION” on page 28.
• Set the present time and screen display.
See “” on pages 34 and 35.
• Set the present time.
See “ ♦ TIME DATE ADJUST” on page 24.
• Set the display mode.
See “ ■ DISPLAY MODE” on page 34.
Setting the HDD (hard disk drive) mode
• Set the repeat recording.
See “ ♦ HDD REPEAT REC MAIN/HDD REPEAT REC SUB” on page 47.
• Set the audio recording.
See “ ■ AUDIO RECORDING” on page 48, and “ ■ Continuous recording time table” on page 77.
• Set the remaining HDD capacity.
See “ ■ REMAIN HDD” on page 50.
• Set the CALL OUT.
See “• HDD MAIN REMAIN/HDD SUB REMAIN” on page 50, and “• HDD MAIN FULL/HDD SUB FULL” on page 51.
• Set the buzzer.
See “ ■ BUZZER” on pages 49 and 50.
Changing the multiplexer function
• Change the SPLIT4 screen setting.
See “ ■ SPLIT4 SCREEN SETTING” on page 37.
• Change the sequence setting.
See “ ■ SEQUENCE SETTING” on page 37.
Setting other various functions
• Change the display mode.
See “ ■ CLOCK LOCATION SETTING” on page 34, and “ ■ DUPLEX MODE DISPLAY” on page 35.
• Set the camera title/memo.
See “ ■ CAMERA TITLE/MEMO SETTING”on pages 34 and 35, and “ ■ CAMERA DISPLAY” on page 34.
• Set to output signals of the unit status.
See “ ♦ MODE OUT 1 to MODE OUT 5” on page 49.