Rts line state, Beep on -17 – Motorola LS3478 User Manual

Page 95

Text mode
Original mode

RS-232 Interface 6 - 17

RTS Line State

This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS line state.

Host: Low RTS

Host: High RTS

Beep on

Single Point Mode Only

When this parameter is enabled, the scanner issues a beep when a character is detected on the RS-232
serial line. is issued to indicate an illegal entry or other important event.

Beep On Character

(Enable)

Do Not Beep On Character

(Disable)

NOTE

This parameter is not supported in Multipoint mode.