Motorola LS3478 - Manual (Page 233)

Advanced Data Formatting 14 - 23
Setup Field(s)
Table 14-1 Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor to a Character
Scan Move Cursor To Character on page 14-24 , then any
printable ASCII character from the Alphanumeric Keyboard .
When this is used, the cursor moves to the position after the
matching character. If the character is not there, the rule fails
and ADF tries the next rule.
14-24
Move Cursor to Start of Data
Scan this bar code to move cursor to the beginning of the
data. 14-24
Move Cursor Past a Character
This parameter moves the cursor past all sequential
occurrences of a selected character. For example, if the
selected character is ‘A,’ then the cursor moves past ‘A,’ ‘AA,’
‘AAA,’ etc. Scan
Move Cursor Past Character on page
14-24 , then select a character from the Alphanumeric
Keyboard . If the character is not there, the cursor does not
move (i.e., has no effect).
14-24
Skip Ahead “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor ahead. 14-25
Skip Back “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor back. 14-27
Send Preset Value Send prefix and/or suffix value by scanning the appropriate
bar code. These values must be set using the Scan Prefix and
Scan Suffix bar codes on
page 13-4 .
14-28