Symbologies, Introduction, Scanning sequence examples – Motorola LS3478 User Manual
Page 155: Errors while scanning, Chapter 12, Chapter 12, symbologies, Describ, Chapter 12 symbologies
Chapter 12 Symbologies
Introduction
This chapter describes symbology features and provides the programming bar codes for selecting these features
for the scanner. Before programming, follow the instructions in
.
The scanner is shipped with the settings shown in the
Symbology Default Table on page 12-2
(also see
A, Standard Default Parameters
for all host device and miscellaneous scanner defaults). If the default values suit
requirements, programming is not necessary. Set feature values by scanning single bar codes or short bar code
sequences. To return all features to default values, scan
.
If not using a Synapse or USB cable, select the host type (see the specific host chapter) after the scanner emits
power-up beeps.
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the
Do Not Transmit UPC-A Check Digit
bar code under
. The scanner issues a fast warble beep and the LED turns green, indicating a successful parameter
entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See the
parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.